![]() ![]() The internal spacing between posts is 72″(1829mm) or96″(2438mm) if full sections are used.Use the provided shims to adjust the verticality. ![]() Choose the appropriate fasteners to fasten the posts according to local building codes.Touch-up, repair or replace damaged products before Substantial Completion. Protect installed products until completion of project.ī. Install in accordance with approved submittals.Ī. Notify the carrier and manufacturer of any damage.Ī. If substrate preparation is the responsibility of another installer, notify Architect of unsatisfactory preparation before proceeding.Ĭ. Do not begin installation until rough opening and structural support have been properly prepared.ī. Completely fabricate aluminum guard rail system ready for installation before shipment to the site.Ī. Hardware: Corrosion resistant hardware and fasteners is standard.Ī. Self-closing gate: Aluminum (6005-T5) 1-1/4” (32 mm) schedule 40 pipe with 1-5/8” (42 mm) OD hinged on open side.Ĥ. Floor Opening Application: Flange style cast aluminum fittings 5-1/2” x 2-3/4” x 1/4” (140 mm by 70 mm by 7 mm).ģ. Roof Hatch Application: Y style 5” x 1-1/4” x 1/8” (127 mm by 32 mm by 4 mm) aluminum square tubing.ī. Capacity: System shall support a load of 200 lbs applied in any direction.ģ.Performance Standard: Unit shall comply with OSHA 1910.28 and OSHA 1910.29.ġ. Aluminum Guard Rail System as manufactured by Precision Ladders, LLC.Ģ. Models: Model AGRS-H**** for a roof hatch mounted aluminum guard rail system or AGRS-F**** for a floor mounted aluminum guard rail system. Aluminum Guard Rail System and Components: Vertical and horizontal rails, mounting brackets, self-closing gate, hardware, and finishes.ġ. Requests for substitutions will be considered in accordance with provisions of Section 01600.Ī. Acceptable Manufacturer: Precision Ladders, LLC, which is located at: P. Defective parts, as deemed by the manufacturer, will be replaced at no charge, freight excluded, upon inspection at manufacturer's plant.Ī. Limited Warranty: Five years against defective material and workmanship, covering parts only. If stored outside, store under a tarp or suitable cover.Ī. Store aluminum guard rail system until installation inside under cover in manufacturer's unopened packaging. Indicate rough opening dimensions for ceiling, roof openings, and/or roof hatch size.Ī. Plan and section of aluminum guard rail system installation.Ģ. Shop Drawings for Aluminum Guard Rail System:ġ. Storage and handling requirements and recommendations.Ĭ. Preparation instructions and recommendations.Ģ. Manufacturer's data sheets on each product to be used, including:ġ. Submit under provisions of Section 01300.ī. OSHA 1910.29: Fall protection systems and falling object protection-criteria and practices.Ī. OSHA 1910.28: Duty to have fall protection and falling object protection.ī. Section 07 42 00 - Wall Panels: Roof curb flashing.Ī. Section 06 10 00 - Rough Carpentry: Roof framing and opening support.ĭ. ![]() Section 05 55 00 - Metal Stair Treads and Nosings: Miscellaneous metal supports.Ĭ. Section 05 12 00 - Structural Steel Framing: Roof structure and opening support.ī.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |